What usually breaks, what the part costs, and how long it takes.
$140 to $650Typical for the part plus the labor to fit it. Drum bearing or outer tub is a different class of job and is quoted on its own.
Any washer repair is two jobs: finding out what broke, and the part to fix it. The part sets the price, because the labor is about the same either way. So nobody can quote you a number until a tech has looked at it.

Which one it is sets the price. The labor is about the same either way, so a cheap part makes a cheap repair. Have the model and serial number off the sticker when you call and ask what the likely part is.
| Part | Typical range |
|---|---|
| Drain pumpNearly always the cause of a machine that will not drain | $180 to $400 |
| Lid or door lock switchThe usual reason a washer will not spin or will not start | $140 to $300 |
| Drive belt or motor couplerWill not spin, or spins without agitating | $150 to $350 |
| Water inlet valveWill not fill, or fills slowly | $150 to $320 |
| Water level or pressure sensorStopping mid cycle, or overfilling | $160 to $350 |
| Suspension rods or dampersWalking across the floor on spin, where levelling has not fixed it | $200 to $450 |
| Main control boardDiagnosed last, because a cheaper sensor usually explains the same symptom | $300 to $650 |
| Drum bearing or outer tubFrequently the point at which a replacement becomes the better value | $600 to $1,200 |
For comparison, a replacement typically runs $700 to $1,600 installed, which is the figure to compare against rather than the shelf price.
The honest answer is a range. The same symptom can have a cheap cause or an expensive one. If the fault is mechanical and easy to reach, expect the low end. If it is sealed, electronic or buried behind a cabinet, expect the high end. Ask for the price of the repair before any work starts.
An Erie winter is heavy, and it is worth planning around. A freezer in an outbuilding can warm up instead of cooling in a hard freeze. The thermostat reads the room, decides it is cold enough, and stops calling for the compressor. Say on the phone whether the appliance is in an unheated room.
Maybe, and it takes about five minutes to find out. Test the outlet with something else, check the breaker, and make sure the door or lid switch is actually catching. Tell us what you already checked. It saves you paying for it twice.
Anything leaking onto a floor needs sorting out now. A washer that will not drain is sitting full of water, so deal with it before the next load goes in. Call it in with the symptom and the model number.
Ask what the repair costs before any work starts. Same-day, any hour.
(716) 414-5233