Appliance repair

Refrigeratorrepair

What goes wrong, which part it usually is, and what moves the price.

$120 to $700Typical for the part plus the labor to fit it. Compressor or sealed system is a different class of job and is quoted on its own.

The short answer

Any refrigerator repair is two jobs: finding out what broke, and the part to fix it. Most of the time the part that failed is a cheap one, so a tech checks those first.

A technician kneeling at a stainless refrigerator with the lower front grille removed, holding a small black cylindrical component.

What usually fails

  • Not cooling at all, which is usually the start relay, the condenser fan or a frosted evaporator coil
  • Cooling in the freezer but not the fresh food section, which points at the evaporator fan or the damper
  • Running constantly without reaching temperature, often a door seal or a blocked condenser
  • Water pooling in the base, normally a blocked defrost drain
  • Loud clicking every few minutes, which is a start relay trying and failing

The part sets the price, not the appliance and not where you live. Have the model and serial number off the sticker when you call. Two machines with the same name on the door can take different parts, and the sticker is the only thing that tells us which.

Typical ranges by part

PartTypical range
Start relay or overload protectorOne of the two cheap failures worth ruling out first on a unit that is not cooling$120 to $250
Condenser or evaporator fan motorThe other one. A clicking every few minutes points here or at the relay$150 to $350
Defrost heater or thermostatHeavy frost on the back wall, or a unit that cools then warms$180 to $400
Thermistor or temperature sensorRunning constantly without reaching temperature$130 to $280
Door gasketVaries most by model; a built in gasket costs far more than a freestanding one$150 to $400
Electronic control boardThe modern cost driver. A mechanical predecessor was a fraction of this$350 to $700
Compressor or sealed systemThe one real cliff. Opening the refrigerant circuit is a different class of job and is quoted on its own$700 to $1,800

For comparison, a replacement typically runs $900 to $2,600 installed, which is the figure to compare against rather than the shelf price.

Before you call

Where to find the model numberThe model number, the symptom in your own words, when it started, and what you have already tried.

By city

Refrigerator in Erie, PAThe same appliance, written for that market.

Questions people ask

What brands are worth repairing?

Whirlpool, GE, Maytag, Frigidaire and LG cover most kitchens around here, and parts for all of them are current. A model dropped ten years ago often still has common parts available even when its control board does not. Get the model number off the sticker and call us.

Can an older refrigerator still be worth fixing?

If one part failed on a machine that has been fine until now, fix it. Count the other repairs it has had. One at ten years old is normal wear. Three in two years is a pattern. The diagnosis answers this. Call and get one.

How much should a repair cost?

A repair bill is two things: the visit that finds the fault, and the part that fixes it. The labor is much the same whether the part is cheap or expensive, so the part price is what separates a small bill from a big one. Get the part named and the price quoted before you say yes.

Can I fix this myself?

Some of this is a five minute check at the back of the machine. Guessing at a part is the expensive way to diagnose. A tech can test the part on the spot with a meter. Ordering a part first means waiting a week just to find out it was not the problem. If the simple checks come up clean, call us and get it diagnosed.

Which appliance problems need attention first?

A warm freezer gives you about a day. A squeaky dryer gives you as long as you like. If a freezer is failing, move the food to another freezer. That buys you the time to get it looked at properly. Call it in with the symptom and the model number.

Can I still get parts for an old appliance?

An appliance built before control boards is often very repairable. An opening sized for a narrower unit is a common reason a repair turns out cheaper than it first looked. Call us with the model and serial number and ask whether the part is still made.

Other appliances

The rest of what gets fixed

Get it diagnosed

Ask for the repair price before any work starts.

(716) 414-5233
Call (716) 414-5233