A squealing or thumping dryer is usually worn drum rollers, a worn idler pulley or a rear drum bearing. All three run $180 to $500 installed. None of it is urgent on its own, with one exception: a burning smell along with the noise means stop using the dryer now.

Free checks first. The cheap causes are also the common ones.
A load of sneakers sounds exactly like a mechanical fault. Take everything out and run the dryer for thirty seconds before you call anybody.
A high squeal that rises as the drum speeds up is usually the idler pulley. A steady thump or rumble in time with the drum turning is usually the drum rollers. A deep grinding is more likely the rear drum bearing, which is the longer job at $250 to $500.
A coin or a screw wedged between the drum and the front bulkhead scrapes in a way that sounds just like a bearing. It costs nothing to fish out and it is worth ruling out first.
A dryer that rocks knocks against its own cabinet, and that sounds far worse than it is. Adjust the feet until the machine does not move when you push a corner.
The rollers, the pulley and the bearing all live behind the cabinet, so reaching them means taking the front or the back off the machine. That is the point to call. A squeal on its own often runs for weeks without getting worse, so it is not an emergency. A burning smell is a different matter: a seized roller rubs against a drum full of lint and gets genuinely hot, so unplug it and leave it until somebody looks at it.
| Part | Typical range |
|---|---|
| Heating elementRuns but will not heat, on an electric dryer | $180 to $400 |
| Thermal fuse or cycling thermostatCheck before the element. A blown fuse is frequently a symptom of a blocked vent rather than a fault | $120 to $260 |
| Igniter or gas valve coilThe gas dryer equivalent of a failed element | $180 to $420 |
| Drum rollers, idler pulley or beltSquealing, rumbling or thumping | $180 to $400 |
| Rear drum bearingA deeper noise than the rollers, and a longer job | $250 to $500 |
| Moisture sensorShutting off early on an auto dry cycle | $140 to $300 |
| Door switch or start switchWill not start at all | $120 to $260 |
| Blower wheelPoor airflow where the vent is already clear | $180 to $380 |
For comparison, a replacement typically runs $650 to $1,500 installed, which is the figure to compare against rather than the shelf price.
If one part failed on a machine that has been fine until now, fix it. The price on the tag hides the rest of it: delivery, hauling the old one away, and any work the opening needs. Find out what broke and what the part costs, then decide.
It depends on which part failed, and that is not a dodge. The spread is real. Age matters through parts, not labor. A current model takes a stock part. An older one may need a part that has to be ordered in. Ask for the full price, parts and labor together, not just the part.
Whirlpool, GE, Maytag, Frigidaire and LG cover most kitchens around here, and parts for all of them are current. Several brands are built on the same platform, so a drain pump or a drive motor is often the same part under two names. Ask what the part is and whether anybody still makes it.
Call with the model number and the list of what you already tried.
(716) 414-5233