An oven that will not heat is almost always one part: the bake element on an electric oven, the igniter on a gas one. The element runs $160 to $350 and the igniter $180 to $400. If the oven heats but cooks hot or cold, the oven sensor is the usual cause at $140 to $320.

Free checks first. The cheap causes are also the common ones.
On an electric oven the bake element across the floor of the cavity should glow orange within a few minutes. A break, a blister or a bright spot on it is the fault, and you can see it. If no part of it glows at all, it is the element, its wiring or the control.
The igniter should glow and the burner should light within about a minute. An igniter that glows but never lights the gas is the most common gas oven fault. It has weakened to the point where it no longer draws enough current to open the gas valve, so it looks like it is working when it is not.
Put an oven thermometer on the middle shelf and set the oven to 350. If it settles well away from 350, the oven sensor is the usual cause. It gets replaced far more often than the thermostat, and at $140 to $320 it is one of the cheaper faults.
A door that does not close square shows up as long cook times before it shows up as anything else. A hinge or a gasket runs $180 to $420, which is well under the $320 to $700 control board people usually blame first.
An element or a gas burner that will NOT SWITCH OFF is a stuck control relay, and that is a hazard rather than an inconvenience. Turn the oven off at the breaker and call. A smell of gas is not a repair question at all: shut the gas off, open a window, get everyone out and call the gas company first. Short of those two, an oven that simply will not heat is one of the few faults you can safely leave for a few days, and gas work is never a DIY job.
| Part | Typical range |
|---|---|
| Bake or broil elementElectric oven that will not heat. Usually visible as a break in the element | $160 to $350 |
| Oven sensorHeats to the wrong temperature. Replaced far more often than a thermostat | $140 to $320 |
| Surface burner igniterA gas burner that clicks without lighting | $150 to $340 |
| Oven igniterThe usual cause of a gas oven that will not heat | $180 to $400 |
| Door hinge or gasketLong cook times, where the door is not sealing | $180 to $420 |
| Control board or relayAn element that stays on is a relay failure and is a hazard, not an inconvenience | $320 to $700 |
For comparison, a replacement typically runs $900 to $2,400 installed, which is the figure to compare against rather than the shelf price.
Have the model and serial number in front of you. Keep any paperwork you have. A machine still inside the maker's warranty is handled differently. Call with the model, the symptom and the date it started.
The part decides the repair, and the model and the year decide the part. LG and Samsung front loaders from the same era share a drain pump fault, and that part is a stock item. Ask what the part is and whether anybody still makes it.
Usually yes, and older machines are often the easier ones to fix. Rebuilt and salvaged boards exist for some models, and they can keep a sound machine running. The sticker on the machine answers this. Have the numbers ready.
Call with the model number and the list of what you already tried.
(716) 414-5233